How Much Concrete Do I Need for a Wall? Work It Out Before You Build the Forms
A wall is unforgiving about concrete maths. A slab that comes up short can be topped up, but a wall poured in forms has to be filled in one go — stop halfway and you get a cold joint right where the wall needs its strength.
The calculation is simple. You need three measurements: the length of the wall, its height, and its thickness.
The formula
Volume in cubic yards = Length (ft) × Height (ft) × (Thickness in inches ÷ 12) ÷ 27
Thickness is usually given in inches, so convert it to feet first — 8 inches is 0.67 feet. The ÷ 27 step matters because there are 27 cubic feet in one cubic yard, and ready-mix concrete is sold by the cubic yard.
A worked example: a 20 ft wall, 4 ft high, 8 in thick
- Volume: 20 × 4 × (8 ÷ 12) = 53.33 cubic feet
- Cubic yards: 53.33 ÷ 27 = 1.98 cubic yards
Add 10% for waste — formwork gaps, spillage, and concrete left in the mixer — and you should order about 2.17 cubic yards.
Bagged concrete follows the same volume. An 80 lb bag yields about 0.60 cubic feet, so 53.33 cubic feet needs about 89 bags, or about 98 bags with the 10% waste allowance (always round bag counts up).
If you would rather not do the arithmetic by hand, run the same numbers through a wall concrete calculator — it gives cubic yards, bag counts and cost in one step.
Two more common sizes, at 8 inches thick
- 10 ft long, 3 ft high: 20 cubic feet → 0.74 cubic yards, about 0.81 with waste. About 34 × 80 lb bags, or 37 with waste.
- 30 ft long, 6 ft high: 120 cubic feet → 4.44 cubic yards, about 4.89 with waste. About 200 × 80 lb bags, or 220 with waste.
How thick should the wall be?
Eight inches is the minimum for most garden retaining walls. Taller walls need thicker sections or reinforcement, and retaining walls over 3 ft high usually need drainage behind them and an engineer check — water pressure is the top cause of wall failure, so add gravel backfill and a drain pipe.
Before you pour
- Measure the total wall length in feet.
- Measure the height from footing to top, in feet.
- Decide the thickness in inches and convert it to feet.
- Work out cubic yards, then add 10% waste, and round bag counts up.
Pour walls in one go where possible, and vibrate or rod the concrete in the forms to remove air pockets.
Comments
Post a Comment